nginx 1.1.12 *) Change: a "proxy_pass" directive without URI part now uses changed URI after redirection with the "error_page" directive; Thanks to Lanshun Zhou. *) Feature: the "proxy/fastcgi/scgi/uwsgi_cache_lock", "proxy/fastcgi/scgi/uwsgi_cache_lock_timeout" directives. *) Feature: the "pcre_jit" directive. *) Feature: the "if" SSI command supports captures in regular expressions. *) Bugfix: the "if" SSI command did not work inside the "block" command. *) Bugfix: the "limit_conn_log_level" and "limit_req_log_level" directives might not work. *) Bugfix: the "limit_rate" directive did not allow to use full throughput, even if limit value was very high. *) Bugfix: the "sendfile_max_chunk" directive did not work, if the "limit_rate" directive was used. *) Bugfix: a "proxy_pass" directive without URI part always used original request URI if variables were used. *) Bugfix: a "proxy_pass" directive without URI part might use original request after redirection with the "try_files" directive; Thanks to Lanshun Zhou. *) Bugfix: in the ngx_http_scgi_module. *) Bugfix: in the ngx_http_mp4_module. *) Bugfix: nginx could not be built on Solaris; the bug had appeared in 1.1.9.

--- a/auto/options
+++ b/auto/options
@@ -111,6 +111,8 @@ NGX_ADDONS=
 USE_PCRE=NO
 PCRE=NONE
 PCRE_OPT=
+PCRE_CONF_OPT=
+PCRE_JIT=NO
 
 USE_OPENSSL=NO
 OPENSSL=NONE
@@ -274,6 +276,7 @@ use the \"--without-http_limit_conn_modu
         --with-pcre)                     USE_PCRE=YES               ;;
         --with-pcre=*)                   PCRE="$value"              ;;
         --with-pcre-opt=*)               PCRE_OPT="$value"          ;;
+        --with-pcre-jit)                 PCRE_JIT=YES               ;;
 
         --with-openssl=*)                OPENSSL="$value"           ;;
         --with-openssl-opt=*)            OPENSSL_OPT="$value"       ;;
@@ -421,6 +424,7 @@ cat << END
   --with-pcre                        force PCRE library usage
   --with-pcre=DIR                    set path to PCRE library sources
   --with-pcre-opt=OPTIONS            set additional build options for PCRE
+  --with-pcre-jit                    build PCRE with JIT compilation support
 
   --with-md5=DIR                     set path to md5 library sources
   --with-md5-opt=OPTIONS             set additional build options for md5