QUIC: ignore duplicate PATH_CHALLENGE frames. According to RFC 9000, an endpoint SHOULD NOT send multiple PATH_CHALLENGE frames in a single packet. The change adds a check to enforce this claim to optimize server behavior. Previously each PATH_CHALLENGE always resulted in a single response datagram being sent to client. The effect of this was however limited by QUIC flood protection. Also, PATH_CHALLENGE is explicitly disabled in Initial and Handshake levels, see RFC 9000, Table 3. However, technically it may be sent by client in 0-RTT over a new path without actual migration, even though the migration itself is prohibited during handshake. This allows client to coalesce multiple 0-RTT packets each carrying a PATH_CHALLENGE and end up with multiple PATH_CHALLENGEs per datagram. This again leads to suboptimal behavior, see above. Since the purpose of sending PATH_CHALLENGE frames in 0-RTT is unclear, these frames are now only allowed in 1-RTT. For 0-RTT they are silently ignored.

# Copyright (C) Igor Sysoev
# Copyright (C) Nginx, Inc.


echo $ngx_n "checking for system byte ordering ...$ngx_c"

cat << END >> $NGX_AUTOCONF_ERR

----------------------------------------
checking for system byte ordering

END


cat << END > $NGX_AUTOTEST.c

int main(void) {
    int i = 0x11223344;
    char *p;

    p = (char *) &i;
    if (*p == 0x44) return 0;
    return 1;
}

END

ngx_test="$CC $CC_TEST_FLAGS $CC_AUX_FLAGS \
          -o $NGX_AUTOTEST $NGX_AUTOTEST.c $NGX_LD_OPT $ngx_feature_libs"

eval "$ngx_test >> $NGX_AUTOCONF_ERR 2>&1"

if [ -x $NGX_AUTOTEST ]; then
    if $NGX_AUTOTEST >/dev/null 2>&1; then
        echo " little endian"
        have=NGX_HAVE_LITTLE_ENDIAN . auto/have
    else
        echo " big endian"
    fi

    rm -rf $NGX_AUTOTEST*

else
    rm -rf $NGX_AUTOTEST*

    echo
    echo "$0: error: cannot detect system byte ordering"
    exit 1
fi