Win32: detection of connect() errors in select(). On Windows, connect() errors are only reported via exceptfds descriptor set from select(). Previously exceptfds was set to NULL, and connect() errors were not detected at all, so connects to closed ports were waiting till a timeout occurred. Since ongoing connect() means that there will be a write event active, except descriptor set is copied from the write one. While it is possible to construct except descriptor set as a concatenation of both read and write descriptor sets, this looks unneeded. With this change, connect() errors are properly detected now when using select(). Note well that it is not possible to detect connect() errors with WSAPoll() (see https://daniel.haxx.se/blog/2012/10/10/wsapoll-is-broken/).

# Copyright (C) Igor Sysoev
# Copyright (C) Nginx, Inc.


NGX_MAKEFILE=$NGX_OBJS/Makefile
NGX_MODULES_C=$NGX_OBJS/ngx_modules.c

NGX_AUTO_HEADERS_H=$NGX_OBJS/ngx_auto_headers.h
NGX_AUTO_CONFIG_H=$NGX_OBJS/ngx_auto_config.h

NGX_AUTOTEST=$NGX_OBJS/autotest
NGX_AUTOCONF_ERR=$NGX_OBJS/autoconf.err

# STUBs
NGX_ERR=$NGX_OBJS/autoconf.err
MAKEFILE=$NGX_OBJS/Makefile


NGX_PCH=
NGX_USE_PCH=


# check the echo's "-n" option and "\c" capability

if echo "test\c" | grep c >/dev/null; then

    if echo -n test | grep n >/dev/null; then
        ngx_n=
        ngx_c=

    else
        ngx_n=-n
        ngx_c=
    fi

else
    ngx_n=
    ngx_c='\c'
fi


# create Makefile

cat << END > Makefile

default:	build

clean:
	rm -rf Makefile $NGX_OBJS
END